Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| lockout_tagout:c13 [2015/06/30 13:37] – zimmer62 | lockout_tagout:c13 [2017/04/05 00:38] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== C13 Tagout Plug ====== | + | ====== C13 Prototype |
| {{: | {{: | ||
| Line 8: | Line 8: | ||
| * The general idea is that this plug will go in an IEC C13. It's currently a rough prototype. | * The general idea is that this plug will go in an IEC C13. It's currently a rough prototype. | ||
| * I'd like to design some compression fins for the inside of each prong hole so that it's a tight fit and will not fall out. | * I'd like to design some compression fins for the inside of each prong hole so that it's a tight fit and will not fall out. | ||
| + | |||
| + | |||
| + | Final Version: | ||
| + | ===== IEC C13 Final Design Tagout Plug ===== | ||
| + | {{: | ||
| + | * {{: | ||