This is an old revision of the document!
I would like to build a Cherry Pi III “ish” delta printer. I will use many of the parts and idea from this forum. And this thingiverse page.
- 5/18/2015 Start of the Cherry Pi III project
- 5/18/2015 Disc's for spool printed.
- 5/19/2015 Tried acetone vapor bath just fro the heck of it.
- 5/20/2015 3D printed parts for base.
Sourcing a few parts have been difficult
- Magnetic balls
- * http://www.magnet4less.com/ need to figure out what to order
Tim recomended the Airtripper Bowden Extruder BSP Edition
Many parts were sourced from eBay, Amazon, or openbuilds.com
I like this Lightweight end effector plate for Delta But it would need various modifications depending on what we attach to it.
Interesting ideas