User Tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
zones:3d_printing_area [2014/11/09 18:54] – zimmer62zones:3d_printing_area [2016/01/28 13:29] (current) – Fixed some outdated info. wreality
Line 3: Line 3:
  
 ===About=== ===About===
-The 3D Printing Area is located on the top floor of Lansing Makers Network.+3D printers live here.
  
 ===Stewards=== ===Stewards===
-Zone Steward: [[user:tim:start|Tim Schmidt]]+Zone Steward: :ORPHANED:
  
 ===3D Printing Zone Tools / Equipment=== ===3D Printing Zone Tools / Equipment===
Line 40: Line 40:
     * Progress: Hot end installed and tested.  Extruding works!     * Progress: Hot end installed and tested.  Extruding works!
       - Question: New hot end topped out at 206 degrees, is that a firmware issue?       - Question: New hot end topped out at 206 degrees, is that a firmware issue?
-    * Progress: Extra long probe arms printed in case they are needed - laying near printer +    * Progress: Jerry Fahner: Longer (blue) probe arm installed, arm angles and offsets determined, firmware reflashed, test print completed. Standard MakerFarm thermister table used but seems to work OK. 
-    * [[user:tim:start|Tim Schmidt]]: determine the offset between nozzle and bed leveling probe, and update the printer's wiki page. +    * FIXME (unclaimed): Some tuning needed with Y-stop. The test print caused chatter when homing Y. 
-    * [[user:tim:start|Tim Schmidt]]: configure and install updated firmware +    * FIXME (unclaimed): Fan over-cools hot end. A piece of tape on fan helped but a shroud is needed. Reversing fan may help.
-    * [[user:tim:start|Tim Schmidt]]: test printing+
     * Progress: [[user:zimmer62:start|Joe Zimmerman]]: soaked magma hotend in acetone, cleaned with fire, polished and is soaking again in the glass container.     * Progress: [[user:zimmer62:start|Joe Zimmerman]]: soaked magma hotend in acetone, cleaned with fire, polished and is soaking again in the glass container.
   * Refurbish the solidoodle 2 3D printer   * Refurbish the solidoodle 2 3D printer

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also, you acknowledge that you have read and understand our Privacy Policy. If you do not agree, please leave the website.

More information