Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| equipment:rostock [2015/08/17 14:08] – zimmer62 | equipment:rostock [2015/09/04 13:02] (current) – zimmer62 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ---- datatemplateentry equipment ---- | ---- datatemplateentry equipment ---- | ||
| template | template | ||
| - | picture | + | picture |
| zone : 3D Printing # zone (Woodshop, Machine Shop, Electronics, | zone : 3D Printing # zone (Woodshop, Machine Shop, Electronics, | ||
| name : Rostock 3D Printer# Descriptive name for the tool | name : Rostock 3D Printer# Descriptive name for the tool | ||
| Line 37: | Line 37: | ||
| * The fan on the power supply was not spinning, I'm not sure if that is a problem since we did not draw much current from the power supply during our tests, but it should be verified that the fan is in fact working, but limited to turns itself on when needed. | * The fan on the power supply was not spinning, I'm not sure if that is a problem since we did not draw much current from the power supply during our tests, but it should be verified that the fan is in fact working, but limited to turns itself on when needed. | ||
| - | Stuff that should be upgrade | + | Stuff that should be upgraded |
| * Add auto bed leveling | * Add auto bed leveling | ||
| * Jerry suggested it would be nice to have the LCD turned up at an angle so you could see it. I think making it adjustable would be ideal. | * Jerry suggested it would be nice to have the LCD turned up at an angle so you could see it. I think making it adjustable would be ideal. | ||