Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
projecst:delta3dprinter:start [2013/10/15 17:12] zimmer62 |
projecst:delta3dprinter:start [2017/04/05 00:38] (current) |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| - Decide on additional Electronics | - Decide on additional Electronics | ||
| - Other electronics needed | - Other electronics needed | ||
| - | * Stepper motors | + | * <del>Stepper motors</del> These were supplied from Dean Piper from Muve |
| * extruder heater(s) | * extruder heater(s) | ||
| * power supply(s) | * power supply(s) | ||
| Line 20: | Line 20: | ||
| 9/18/2013. Rumba and endstops ordered from reprapdiscount. | 9/18/2013. Rumba and endstops ordered from reprapdiscount. | ||
| - | We need to source the stepper motors and additional electronics. Ask Mike about the cost of the steppers from sparkfun.com | + | We need to source the <del>stepper motors</del> and additional electronics. <del>Ask Mike about the cost of the steppers from sparkfun.com</del> |
| 9/27/2013. Rumba, endstops, wiring kit, arrived. | 9/27/2013. Rumba, endstops, wiring kit, arrived. | ||
| - | There are 4 matching Nema 17 motors on the shapoko in the basement. (3 on the machine and 1 spare) I think these will work and we can take them and replace the motors on the shapoko with Nema 23's | + | <del>There are 4 matching Nema 17 motors on the shapoko in the basement. (3 on the machine and 1 spare) I think these will work and we can take them and replace the motors on the shapoko with Nema 23's</del> |
| - | Brent Morse also has offered up some stepper motors. I also have a bunch of motors pulled from machines. 3 motors should be identical, it would be nice to have a total of 6 motors on hand. | + | <del>Brent Morse also has offered up some stepper motors. I also have a bunch of motors pulled from machines. 3 motors should be identical, it would be nice to have a total of 6 motors on hand.</del> |
| I saw a video of a rostock with quick change heads, this one in particular was making a pancake. | I saw a video of a rostock with quick change heads, this one in particular was making a pancake. | ||
| Line 48: | Line 48: | ||
| - | I stole the heat sinks from this for the solidoode2 printer I have, I'll try and order some more. | + | <del>I stole the heat sinks from this for the solidoode2 printer I have. I've ordered replacements, they will be here by Thursday.</del> Heat sinks have been replaced and installed. |
| I've also ordered and LCD screen hopefully it's easy to integrate with this board. | I've also ordered and LCD screen hopefully it's easy to integrate with this board. | ||
| + | A Half built rostock with motors, but not electronics was donated by Dean Piper from [[www.muve3d.net|Muve3d]] | ||