Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:makerfarm-i3 [2015/08/29 16:15] jfahner3 |
equipment:makerfarm-i3 [2017/04/05 00:38] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
---- datatemplateentry equipment ---- | ---- datatemplateentry equipment ---- | ||
template : templates:equipment | template : templates:equipment | ||
- | picture : :equipment:makerfarm-i3:makerfarm_v1.jpg | + | picture : :equipment:makerfarm-i3:img_7841.jpg |
zone : 3D Printing | zone : 3D Printing | ||
name : Makerfarm Prusa i3 3d Printer | name : Makerfarm Prusa i3 3d Printer | ||
Line 61: | Line 61: | ||
* beginning and ending Gcode scripts | * beginning and ending Gcode scripts | ||
* auto bed leveling code | * auto bed leveling code | ||
+ | * OctoPrint has been updated from 1.2.4 to 1.2.5(stable) using the interface | ||
+ | * Added the following plugins | ||
+ | * Custom Control Editor | ||
+ | * System Command Editor | ||
+ | * Editor Collection | ||
+ | * EEPROM Marlin Editor | ||
+ | * Print History | ||
+ | * STL Viewer | ||
+ | * Added stub commands to control the lighting | ||
+ | * Currently using M42 P4 S255 / M42 P4 S0 | ||
+ | * We still need a relay hooked up to this pin to drive a light. | ||
* Still needs done: | * Still needs done: | ||
* 3D Print an enclosure for the pi | * 3D Print an enclosure for the pi | ||
Line 74: | Line 85: | ||
* Add LED/Lamp for Camera | * Add LED/Lamp for Camera | ||
* Drive it from Ramps either: | * Drive it from Ramps either: | ||
- | * in parallel to fans | + | * Using an M42 G-code and the octoprint command plug in creating a couple buttons should be easy |
- | * in parallel to Motors being energized | + | * http://neverstopbuilding.com/bed-lighting |
- | * Add a G-Code (there may already be one) and create OctoPrint Plug-In | + | * http://plugins.octoprint.org/plugins/customControl/ |
+ | * Other ideas include: | ||
+ | * in parallel to fans | ||
+ | * in parallel to Motors being energized | ||
* Consider all possible scenarios for overheating or loss of control | * Consider all possible scenarios for overheating or loss of control | ||
* Address the issue of the PSU load which is not connected well and also may overheat nearby objects | * Address the issue of the PSU load which is not connected well and also may overheat nearby objects | ||
+ | * A backup of the SD card should be done, and some sort of regular backup system should be in place so if something is ever broken we have a place in time to restore to. | ||
* Considerations: | * Considerations: | ||
* LDAP authentication or equivalent for future https://github.com/foosel/OctoPrint/issues/594 | * LDAP authentication or equivalent for future https://github.com/foosel/OctoPrint/issues/594 |