Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
zones:3d_printing_area [2014/12/03 18:33] jfahner3 |
zones:3d_printing_area [2014/12/03 18:51] jfahner3 |
||
|---|---|---|---|
| Line 40: | Line 40: | ||
| * Progress: Hot end installed and tested. Extruding works! | * Progress: Hot end installed and tested. Extruding works! | ||
| - Question: New hot end topped out at 206 degrees, is that a firmware issue? | - Question: New hot end topped out at 206 degrees, is that a firmware issue? | ||
| - | * Progress: Jerry Fahner:Longer probe arm installed, arm angles and offsets determined, firmware reflashed, test print completed. | + | * Progress: Jerry Fahner: Longer (blue) probe arm installed, arm angles and offsets determined, firmware reflashed, test print completed. Standard MakerFarm thermister table used but seems to work OK. |
| - | * FIXME (unclaimed): Some tuning needed with y-stop. | + | * FIXME (unclaimed): Some tuning needed with Y-stop. The test print caused chatter when homing Y. |
| - | * FIXME (unclaimed) : Fan overcools hot end. A piece of tape on fan helped but a shroud is needed. | + | * FIXME (unclaimed): Fan over-cools hot end. A piece of tape on fan helped but a shroud is needed. Reversing fan may help. |
| * Progress: [[user:zimmer62:start|Joe Zimmerman]]: soaked magma hotend in acetone, cleaned with fire, polished and is soaking again in the glass container. | * Progress: [[user:zimmer62:start|Joe Zimmerman]]: soaked magma hotend in acetone, cleaned with fire, polished and is soaking again in the glass container. | ||
| * Refurbish the solidoodle 2 3D printer | * Refurbish the solidoodle 2 3D printer | ||