Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
zones:3d_printing_area [2014/11/09 23:54] zimmer62 |
zones:3d_printing_area [2014/12/03 18:33] jfahner3 |
||
---|---|---|---|
Line 40: | Line 40: | ||
* Progress: Hot end installed and tested. Extruding works! | * Progress: Hot end installed and tested. Extruding works! | ||
- Question: New hot end topped out at 206 degrees, is that a firmware issue? | - Question: New hot end topped out at 206 degrees, is that a firmware issue? | ||
- | * Progress: Extra long probe arms printed in case they are needed - laying near printer | + | * Progress: Jerry Fahner:Longer probe arm installed, arm angles and offsets determined, firmware reflashed, test print completed. |
- | * [[user:tim:start|Tim Schmidt]]: determine the offset between nozzle and bed leveling probe, and update the printer's wiki page. | + | * FIXME (unclaimed): Some tuning needed with y-stop. |
- | * [[user:tim:start|Tim Schmidt]]: configure and install updated firmware | + | * FIXME (unclaimed) : Fan overcools hot end. A piece of tape on fan helped but a shroud is needed. |
- | * [[user:tim:start|Tim Schmidt]]: test printing | + | |
* Progress: [[user:zimmer62:start|Joe Zimmerman]]: soaked magma hotend in acetone, cleaned with fire, polished and is soaking again in the glass container. | * Progress: [[user:zimmer62:start|Joe Zimmerman]]: soaked magma hotend in acetone, cleaned with fire, polished and is soaking again in the glass container. | ||
* Refurbish the solidoodle 2 3D printer | * Refurbish the solidoodle 2 3D printer |