Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
zones:3d_printing_area [2014/11/06 14:33] jfahner3 |
zones:3d_printing_area [2014/11/06 14:40] jfahner3 |
||
---|---|---|---|
Line 39: | Line 39: | ||
* Get the Makerfarm printing reliably | * Get the Makerfarm printing reliably | ||
* Progress: Hot end installed and tested. Extruding works! | * Progress: Hot end installed and tested. Extruding works! | ||
+ | * Progress: Extra long probe arms printed in case they are needed - laying near printer | ||
* [[user:tim:start|Tim Schmidt]]: determine the offset between nozzle and bed leveling probe, and update the printer's wiki page. | * [[user:tim:start|Tim Schmidt]]: determine the offset between nozzle and bed leveling probe, and update the printer's wiki page. | ||
* [[user:tim:start|Tim Schmidt]]: configure and install updated firmware | * [[user:tim:start|Tim Schmidt]]: configure and install updated firmware |