Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
zones:3d_printing_area [2014/10/28 20:30] tim |
zones:3d_printing_area [2014/11/06 14:40] jfahner3 |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| * establish LMN-purchased stock, which can be paid for per-print via Cura / Repetier cost estimation | * establish LMN-purchased stock, which can be paid for per-print via Cura / Repetier cost estimation | ||
| * purchase / install fast-heating bed heaters on all printers: http://www.ebay.com/itm/like/191353869307?lpid=82 | * purchase / install fast-heating bed heaters on all printers: http://www.ebay.com/itm/like/191353869307?lpid=82 | ||
| + | * maintain two or more working 3D printers at all times. | ||
| ===Ongoing Projects=== | ===Ongoing Projects=== | ||
| Line 38: | Line 39: | ||
| * Get the Makerfarm printing reliably | * Get the Makerfarm printing reliably | ||
| * Progress: Hot end installed and tested. Extruding works! | * Progress: Hot end installed and tested. Extruding works! | ||
| + | * Progress: Extra long probe arms printed in case they are needed - laying near printer | ||
| * [[user:tim:start|Tim Schmidt]]: determine the offset between nozzle and bed leveling probe, and update the printer's wiki page. | * [[user:tim:start|Tim Schmidt]]: determine the offset between nozzle and bed leveling probe, and update the printer's wiki page. | ||
| * [[user:tim:start|Tim Schmidt]]: configure and install updated firmware | * [[user:tim:start|Tim Schmidt]]: configure and install updated firmware | ||