Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
lockout_tagout:start [2015/06/30 13:36]
zimmer62 [In Progress]
lockout_tagout:start [2017/04/05 00:38] (current)
Line 12: Line 12:
   * {{:​lockout_tagout:​lockou_tagout_1_sheet.pdf|Printable PDF for lockout tags}}   * {{:​lockout_tagout:​lockou_tagout_1_sheet.pdf|Printable PDF for lockout tags}}
   * {{:​lockout_tagout:​lockou_tagout_1_sheet.ai|Adobe Illustrator for lockout tags}}   * {{:​lockout_tagout:​lockou_tagout_1_sheet.ai|Adobe Illustrator for lockout tags}}
 +
 +===== IEC C13 Tagout =====
 +{{:​lockout_tagout:​c13-sideview.jpg?​150|}}{{:​lockout_tagout:​c13-plugside.jpg?​229|}}
 +  * {{:​lockout_tagout:​c13_tagout_source_files_freecad_and_stl.zip|FreeCad and STL Source files}}
 +
 +===== Example Tagout installations =====
 +{{:​lockout_tagout:​image1_2_.jpg?​200|}}
 +{{:​lockout_tagout:​image2_2_.jpg?​200|}}
 +{{:​lockout_tagout:​image3.jpg?​200|}}
  
 ===== To do ===== ===== To do =====
-  * 40 Tags have been printed, however they need to be cut out and laminated 
   * A box in each area that can hold tags / locks etc, sharpies, log book, and brochures. ​   * A box in each area that can hold tags / locks etc, sharpies, log book, and brochures. ​
     * Probably keep one log book for the space, but tags and instructions near each area.     * Probably keep one log book for the space, but tags and instructions near each area.
   * Design and implement an online wiki log book   * Design and implement an online wiki log book
 +  * 32 Tags need holes cut in them with a hole punch 
 +  * very small zip ties are needed 
 +  * Sharpies for each box are needed
 ==== In Progress ==== ==== In Progress ====
   * Jerry is designing a brochure.   * Jerry is designing a brochure.
-  * Joe is designing an IEC C13 3D printable plug to tagout a device which accepts that kind of power cord 
-    * use the dimensions from [[http://​www.mouser.com/​catalog/​specsheets/​KC-301194.pdf|Here]] 
-    * Here are some images of the latest prototype: [[lockout_tagout:​c13|C13 Tagout Plug]] 
  
 ==== Already done ==== ==== Already done ====
   * Printed 40 tags   * Printed 40 tags
 +  * 40 Tags have been cut out and laminated -- 8 tags were destroyed by the laminater. ​
 +    * 32 tags are on the chalkboard near the entrance.
 +  * Joe designed an IEC C13 3D printable plug to tagout a device which accepts that kind of power cord
 +    * Used the dimensions from [[http://​www.mouser.com/​catalog/​specsheets/​KC-301194.pdf|Here]]
 +    * Here are some images of the latest prototype: [[lockout_tagout:​c13|C13 Tagout Plug]]
 +
 +