Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
lockout_tagout:start [2015/06/26 03:25] zimmer62 |
lockout_tagout:start [2015/07/03 20:38] zimmer62 |
||
---|---|---|---|
Line 8: | Line 8: | ||
* It can also be used to identify a machine that is out of service that would be dangerous to energize. | * It can also be used to identify a machine that is out of service that would be dangerous to energize. | ||
* [[https://en.wikipedia.org/wiki/Lockout-tagout|wikipedia entry about lockout tagout]] | * [[https://en.wikipedia.org/wiki/Lockout-tagout|wikipedia entry about lockout tagout]] | ||
+ | |||
+ | ===== Resources ===== | ||
+ | * {{:lockout_tagout:lockou_tagout_1_sheet.pdf|Printable PDF for lockout tags}} | ||
+ | * {{:lockout_tagout:lockou_tagout_1_sheet.ai|Adobe Illustrator for lockout tags}} | ||
+ | |||
+ | ===== IEC C13 Tagout ===== | ||
+ | {{:lockout_tagout:c13-sideview.jpg?150|}}{{:lockout_tagout:c13-plugside.jpg?229|}} | ||
+ | * {{:lockout_tagout:c13_tagout_source_files_freecad_and_stl.zip|FreeCad and STL Source files}} | ||
+ | |||
+ | ===== Example Tagout installations ===== | ||
+ | {{:lockout_tagout:image1_2_.jpg?200|}} | ||
+ | {{:lockout_tagout:image2_2_.jpg?200|}} | ||
+ | {{:lockout_tagout:image3.jpg?200|}} | ||
+ | |||
+ | ===== To do ===== | ||
+ | * A box in each area that can hold tags / locks etc, sharpies, log book, and brochures. | ||
+ | * Probably keep one log book for the space, but tags and instructions near each area. | ||
+ | * Design and implement an online wiki log book | ||
+ | * 32 Tags need holes cut in them with a hole punch | ||
+ | * very small zip ties are needed | ||
+ | * Sharpies for each box are needed | ||
+ | ==== In Progress ==== | ||
+ | * Jerry is designing a brochure. | ||
+ | |||
+ | ==== Already done ==== | ||
+ | * Printed 40 tags | ||
+ | * 40 Tags have been cut out and laminated -- 8 tags were destroyed by the laminater. | ||
+ | * 32 tags are on the chalkboard near the entrance. | ||
+ | * Joe designed an IEC C13 3D printable plug to tagout a device which accepts that kind of power cord | ||
+ | * Used the dimensions from [[http://www.mouser.com/catalog/specsheets/KC-301194.pdf|Here]] | ||
+ | * Here are some images of the latest prototype: [[lockout_tagout:c13|C13 Tagout Plug]] | ||