Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
lockout_tagout:c13 [2015/06/30 13:35] zimmer62 created |
lockout_tagout:c13 [2017/04/05 00:38] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== C13 Tagout Plug ====== | + | ====== C13 Prototype Tagout Plug ====== |
{{:lockout_tagout:img_5571.jpg?direct&400|}} | {{:lockout_tagout:img_5571.jpg?direct&400|}} | ||
Line 6: | Line 6: | ||
{{:lockout_tagout:img_5574.jpg?direct&400|}} | {{:lockout_tagout:img_5574.jpg?direct&400|}} | ||
- | The general idea is that this plug will go in an IEC C13 | + | * The general idea is that this plug will go in an IEC C13. It's currently a rough prototype. |
+ | * I'd like to design some compression fins for the inside of each prong hole so that it's a tight fit and will not fall out. | ||
+ | |||
+ | |||
+ | Final Version: | ||
+ | ===== IEC C13 Final Design Tagout Plug ===== | ||
+ | {{:lockout_tagout:c13-sideview.jpg?150|}}{{:lockout_tagout:c13-plugside.jpg?229|}} | ||
+ | * {{:lockout_tagout:c13_tagout_source_files_freecad_and_stl.zip|FreeCad and STL Source files}} |