Differences
This shows you the differences between two versions of the page.
|
lockout_tagout:c13 [2015/07/03 20:39] zimmer62 |
lockout_tagout:c13 [2017/04/05 00:38] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== C13 Prototype Tagout Plug ====== | ||
| - | {{:lockout_tagout:img_5571.jpg?direct&400|}} | ||
| - | {{:lockout_tagout:img_5572.jpg?direct&400|}} | ||
| - | {{:lockout_tagout:img_5573.jpg?direct&400|}} | ||
| - | {{:lockout_tagout:img_5574.jpg?direct&400|}} | ||
| - | |||
| - | * The general idea is that this plug will go in an IEC C13. It's currently a rough prototype. | ||
| - | * I'd like to design some compression fins for the inside of each prong hole so that it's a tight fit and will not fall out. | ||
| - | |||
| - | |||
| - | Final Version: | ||
| - | ===== IEC C13 Final Design Tagout Plug ===== | ||
| - | {{:lockout_tagout:c13-sideview.jpg?150|}}{{:lockout_tagout:c13-plugside.jpg?229|}} | ||
| - | * {{:lockout_tagout:c13_tagout_source_files_freecad_and_stl.zip|FreeCad and STL Source files}} | ||