Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
equipment:makerfarm-i3 [2015/08/31 13:22] zimmer62 |
equipment:makerfarm-i3 [2015/09/01 19:21] zimmer62 |
||
|---|---|---|---|
| Line 61: | Line 61: | ||
| * beginning and ending Gcode scripts | * beginning and ending Gcode scripts | ||
| * auto bed leveling code | * auto bed leveling code | ||
| + | * OctoPrint has been updated from 1.2.4 to 1.2.5(stable) using the interface | ||
| * Still needs done: | * Still needs done: | ||
| * 3D Print an enclosure for the pi | * 3D Print an enclosure for the pi | ||
| Line 80: | Line 81: | ||
| * in parallel to fans | * in parallel to fans | ||
| * in parallel to Motors being energized | * in parallel to Motors being energized | ||
| - | |||
| * Consider all possible scenarios for overheating or loss of control | * Consider all possible scenarios for overheating or loss of control | ||
| * Address the issue of the PSU load which is not connected well and also may overheat nearby objects | * Address the issue of the PSU load which is not connected well and also may overheat nearby objects | ||
| + | * A backup of the SD card should be done, and some sort of regular backup system should be in place so if something is ever broken we have a place in time to restore to. | ||
| * Considerations: | * Considerations: | ||
| * LDAP authentication or equivalent for future https://github.com/foosel/OctoPrint/issues/594 | * LDAP authentication or equivalent for future https://github.com/foosel/OctoPrint/issues/594 | ||