Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
equipment:makerfarm-i3 [2015/08/29 16:15] jfahner3 |
equipment:makerfarm-i3 [2015/08/31 13:22] zimmer62 |
||
|---|---|---|---|
| Line 74: | Line 74: | ||
| * Add LED/Lamp for Camera | * Add LED/Lamp for Camera | ||
| * Drive it from Ramps either: | * Drive it from Ramps either: | ||
| - | * in parallel to fans | + | * Using an M42 G-code and the octoprint command plug in creating a couple buttons should be easy |
| - | * in parallel to Motors being energized | + | * http://neverstopbuilding.com/bed-lighting |
| - | * Add a G-Code (there may already be one) and create OctoPrint Plug-In | + | * http://plugins.octoprint.org/plugins/customControl/ |
| + | * Other ideas include: | ||
| + | * in parallel to fans | ||
| + | * in parallel to Motors being energized | ||
| * Consider all possible scenarios for overheating or loss of control | * Consider all possible scenarios for overheating or loss of control | ||
| * Address the issue of the PSU load which is not connected well and also may overheat nearby objects | * Address the issue of the PSU load which is not connected well and also may overheat nearby objects | ||
| * Considerations: | * Considerations: | ||
| * LDAP authentication or equivalent for future https://github.com/foosel/OctoPrint/issues/594 | * LDAP authentication or equivalent for future https://github.com/foosel/OctoPrint/issues/594 | ||