Differences
This shows you the differences between two versions of the page.
equipment:jet-band-saw [2014/05/10 19:40] wreality |
equipment:jet-band-saw [2017/04/05 00:38] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ---- datatemplateentry equipment ---- | ||
- | template : templates:equipment | ||
- | picture : equipment:jetbandsaw.jpg | ||
- | zone : Woodshop | ||
- | name : JET 14" Bandsaw | ||
- | manufacturer : JET | ||
- | model : JWBS-14OS | ||
- | manual : equipment:jet-bandsaw-model-jwbs-14cs.pdf | ||
- | memberlevel : Full | ||
- | owner : Lansing Makers Network | ||
- | type : Bandsaw | ||
- | status_ : Operational | ||
- | ---- | ||
- | |||
- | ===Description=== | ||
- | A bandsaw uses a blade consisting of a continuous band of metal with teeth along one edge to cut various workpieces. The band rides on two wheels rotating in the same plane. Bandsawing produces uniform cutting action as a result of an evenly distributed tooth load. Bandsaws are used for woodworking, metalworking, or for cutting a variety of other materials. They are particularly useful for cutting irregular or curved shapes, but can make straight cuts. The minimum radius of a curve that can be cut on a particular saw is determined by the width of the band and its kerf. | ||
- | ===Safety Rules=== | ||
- | In addition to the [[zones:shop safety rules]] the following should be observed when using this tool. | ||
- | * Follow the 3” rule from the blade; always keep fingers 3” from the blade. | ||
- | * Check the blade tension and tracking before starting. | ||
- | * Don’t cut stock that is not flat on the bottom without a jig. | ||
- | * Keep a balanced stance at the band saw. | ||
- | * Never clear small pieces while the blade is moving. | ||
- | * Never use your thumbs to push toward the blade. | ||
- | * Never back out of a curve cut while the machine is running. | ||
- | ===Useful Links=== | ||
- | * [[http://www.cs.rpi.edu/twiki/pub/RoboticsWeb/WebFacilities/BandsawSafety.pdf|KCWG Bandsaw Safety Rules]] | ||
- | ===Contacts for training== | ||
- | Contact [[user:wreality:start|Brian Adams]] or [[user:carlraymond:start|Carl Raymond]] for safety training. | ||
- | ===Safety Training=== | ||
- | * Review of machine and shop safety rules. | ||
- | * Proper procedures for preparing / setup operations. | ||
- | * Proper operation and control of machine. | ||
- | * Proper procedures for cleanup. |