Differences
This shows you the differences between two versions of the page.
|
equipment:cm97181 [2014/05/16 06:58] wreality created |
equipment:cm97181 [2017/04/05 00:38] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ---- datatemplateentry equipment ---- | ||
| - | template : templates:equipment | ||
| - | picture : :equipment:woodshop:cm97181.jpg | ||
| - | zone : Woodshop | ||
| - | name : 4 In. X 36 In. Belt / 6 In. Disc Sander | ||
| - | manufacturer : Central Machinery | ||
| - | model : 97181 | ||
| - | manual : {{:equipment:woodshop:97181.pdf|}} | ||
| - | memberlevel : Full | ||
| - | owner : LMN | ||
| - | type : Belt Sander | ||
| - | status_ : Operational | ||
| - | ---- | ||
| - | |||
| - | ===Description=== | ||
| - | |||
| - | ===Safety Rules=== | ||
| - | In Addition to the [[zones:shop safety rules]] the following safety rules should be followed: | ||
| - | * Always sand on the downward motion side of the disc/belt. Never the upward motion side as this can throw your part upwards with tremendous force. | ||
| - | * Always attempt to place your work against the rest on the disc and belt sanders and hold the work securely. | ||
| - | * When using the horizontal belt sander, always sand so that the belt motion is away from you. | ||
| - | * Do not operate machines with torn or ripped belts or disks. | ||
| - | * Always sand on the down travel side of the disc / belt. | ||
| - | * The rest should be adjusted so that it is no more than 1/8” from the disc. | ||
| - | * Make adjustments only when the sander is at a complete stop. | ||
| - | * Keep fingers away from the abrasive surface on the sander. | ||
| - | * Avoid pressure against the disc. Feed stock into the abrasive material at a moderate rate of feed and pressure. | ||
| - | * Stock that is 1” or smaller in length should not be sanded. | ||
| - | * Use the disc sander for sanding outside curves or angles only. | ||
| - | * The disc sander is NOT to be used for joinery, squaring stock, etc. | ||
| - | * Any disc that is dull or loose should be repaired or replaced immediately. | ||
| - | ===Contacts for training== | ||
| - | * [[user:wreality:start|Brian Adams]] | ||
| - | |||
| - | ===Safety Training=== | ||
| - | |||
| - | |||
| - | ===Maintenance Log=== | ||