Differences

This shows you the differences between two versions of the page.

--- equipment:8in-drill-press-woodshop [2017/04/05 00:38]
+++ equipment:8in-drill-press-woodshop [2017/04/05 00:38] (current)
@@ Line 1: / Line 1: @@
+---- datatemplateentry equipment ----
+template      : templates:equipment
+picture       : :equipment:8in_drill_press.jpg
+zone          : Woodshop
+name          : 8 inch Central Machinery Drill Press
+manufacturer  : Central Machinery
+model         : 44506
+manual        : equipment:44506.pdf
+memberlevel   : Full
+owner         : Tim Schmidt
+type          : Drill Press
+status_       : Operational
+----
+===Description===
+A drill press is a fixed style of drill that may be mounted on a stand or bolted to the floor or workbench. A drill press consists of a base, column , table, spindle, and drill head. The head has a set of handles radiating from a central hub that, when turned, move the spindle and chuck vertically, parallel to the axis of the column. The table can be adjusted vertically.
+===Safety Rules===
+In addition to the [[zones:shop safety rules]] the following rules should be followed.
+  * A two foot perimeter around the drill press should be kept clear of people, debris and sawdust that impair traction or footing to avoid slips and falls.
+  * Safety glasses with side shields or a face shield must be worn. Hearing protection should be worn.
+  * Remove loose fitting clothing, jewelry, and tie back long hair.
+  * Give the work your undivided attention.
+  * Do not wear gloves or anything that would allow a hand, fingers or clothing to be wrapped around the revolving bit.
+===Contacts for training==
+  * Tim Schmidt
+  * Brian Adams
+  * Carl Raymond
+===Safety Training===
+  * Review of machine and shop safety rules.
+  * Proper procedures for preparing / setup operations.
+  * Proper operation and control of machine.
+  * Proper procedures for cleanup.
+===Maintenance Log===