Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
delta3dprinter [2013/09/27 20:56] zimmer62 |
delta3dprinter [2013/10/02 17:42] zimmer62 |
||
|---|---|---|---|
| Line 22: | Line 22: | ||
| We need to source the stepper motors and additional electronics. Ask Mike about the cost of the steppers from sparkfun.com | We need to source the stepper motors and additional electronics. Ask Mike about the cost of the steppers from sparkfun.com | ||
| - | 9/27/2013. Rumba, endstops, wiring kit, arrived. Currently @ Joe Zimmerman's house, will Bring to LMN on Monday. | + | 9/27/2013. Rumba, endstops, wiring kit, arrived. |
| There are 4 matching Nema 17 motors on the shapoko in the basement. (3 on the machine and 1 spare) I think these will work and we can take them and replace the motors on the shapoko with Nema 23's | There are 4 matching Nema 17 motors on the shapoko in the basement. (3 on the machine and 1 spare) I think these will work and we can take them and replace the motors on the shapoko with Nema 23's | ||
| Line 33: | Line 33: | ||
| I think I'd like to know more about the pros and cons of quick change heads. I'd love to have 2 or 3 color extrusion, this might be a good way to do that without adding inertia problems to the head itself. | I think I'd like to know more about the pros and cons of quick change heads. I'd love to have 2 or 3 color extrusion, this might be a good way to do that without adding inertia problems to the head itself. | ||
| + | |||
| + | 10/2/2013 The rumba kit is in, located near the laser cutter by the delta printer board | ||
| + | |||