Always sand on the downward motion side of the disc/belt. Never the upward motion side as this can throw your part upwards with tremendous force.
Always attempt to place your work against the rest on the disc and belt sanders and hold the work securely.
When using the horizontal belt sander, always sand so that the belt motion is away from you.
Do not operate machines with torn or ripped belts or disks.
Always sand on the down travel side of the disc / belt.
The rest should be adjusted so that it is no more than 1/8” from the disc.
Make adjustments only when the sander is at a complete stop.
Keep fingers away from the abrasive surface on the sander.
Avoid pressure against the disc. Feed stock into the abrasive material at a moderate rate of feed and pressure.
Stock that is 1” or smaller in length should not be sanded.
Use the disc sander for sanding outside curves or angles only.
The disc sander is NOT to be used for joinery, squaring stock, etc.
Any disc that is dull or loose should be repaired or replaced immediately.