Delta 3d Printer Mission: To create a delta based 3d printer for donation to LMN I Joe Zimmerman proposed to donate 50% of the cost of time and materials in creating a delta 3d printer such as the rostock http://reprap.org/wiki/Rostock Some basic discussion has been started here: https://groups.google.com/forum/#!topic/lansing-makers-network/y3_D3-leakI - Determine which style printer we will attempt to build. - Decide on additional Electronics - Other electronics needed * Stepper motors These were supplied from Dean Piper from Muve * extruder heater(s) * power supply(s) * heated bed 9/18/2013. Rumba and endstops ordered from reprapdiscount. We need to source the stepper motors and additional electronics. Ask Mike about the cost of the steppers from sparkfun.com 9/27/2013. Rumba, endstops, wiring kit, arrived. There are 4 matching Nema 17 motors on the shapoko in the basement. (3 on the machine and 1 spare) I think these will work and we can take them and replace the motors on the shapoko with Nema 23's Brent Morse also has offered up some stepper motors. I also have a bunch of motors pulled from machines. 3 motors should be identical, it would be nice to have a total of 6 motors on hand. I saw a video of a rostock with quick change heads, this one in particular was making a pancake. http://www.thingiverse.com/thing:156715 (watch the attached video) I think I'd like to know more about the pros and cons of quick change heads. I'd love to have 2 or 3 color extrusion, this might be a good way to do that without adding inertia problems to the head itself. 10/2/2013 The rumba kit is in, located near the laser cutter by the delta printer board {{:projecst:delta3dprinter:img_6874.jpg?direct&300|rumba board}} {{:projecst:delta3dprinter:img_6881.jpg?direct&300|sd card reader}} {{:projecst:delta3dprinter:img_6879.jpg?direct&300|heat sinks}} {{:projecst:delta3dprinter:img_6875.jpg?direct&300|wires}} {{:projecst:delta3dprinter:img_6878.jpg?direct&300|fan}} {{:projecst:delta3dprinter:img_6873.jpg?direct&300|end stops}} {{:projecst:delta3dprinter:img_6876.jpg?direct&300|temp sensors}} {{:projecst:delta3dprinter:img_6880.jpg?direct&300|pulleys}} {{:projecst:delta3dprinter:img_6882.jpg?direct&300|}} I stole the heat sinks from this for the solidoode2 printer I have. I've ordered replacements, they will be here by Thursday. Heat sinks have been replaced and installed. I've also ordered and LCD screen hopefully it's easy to integrate with this board. A Half built rostock with motors, but not electronics was donated by Dean Piper from [[www.muve3d.net|Muve3d]]