---- datatemplateentry equipment ----
template      : templates:equipment
picture       : equipment:lmscncmill.jpg
zone          : Machine Shop
name          : CNC Mill
manufacturer  : Little Machine Shop
model         : LMS-3960
manual        : equipment:3960_mini_mil_lusers_guide.pdf
memberlevel   : Full
owner         : Carl Raymond
type          : CNC Mill
status_       : Operational

----

===Description===

This mill is a CNC conversion of Little Machine Shop's High Torque Mini Mill.  It also has the high speed spindle upgrade installed, doubling the max spindle speed to 5000 RPM.

===Specifications===

^ End Milling Capacity	| 0.6" (16 mm) |
^ Face Milling Capacity	| 1.2" (30 mm) |
^ Drilling Capacity	| 0.5" (13 mm) |
^ Table Size	        | 18.1" x 4.7" (460 mm x 120 mm) |
^ X-Axis Travel	        | 11.8" (300 mm) |
^ Y-Axis Travel	        | 5.1" (130 mm) |
^ Z-Axis Travel	        | 9.8" (250 mm) |
^ Throat	        | 6.5" (165 mm) |
^ Head Tilt	        | None          |
^ Spindle Taper	        | R8            |
^ Spindle Motor	        | 0.67 hp (500 Watts) |
^ Spindle Speed	        | 200 - 5000 RPM |

===Safety Rules===
In addition to the [[zones:Shop Safety Rules| standard shop safety rules]] for the machine shop:
  * Do not make contact with the revolving cutter.
  * Place a wooden pad or suitable cover over the table surface to protect it from possible damage.
  * Use the buddy system when moving heavy attachments.
  * Do not attempt to tighten arbor nuts using machine power.
  * When installing or removing milling cutters, always hold them with a rag to prevent cutting your hands.
  * While setting up work, install the cutter last to avoid being cut.
  * Never adjust the workpiece or work mounting devices when the machine is operating
  * Chips should be removed from the workpiece with an appropriate rake and a brush.
  * Shut the machine off before making any adjustments or measurements.
  * When using cutting oil, prevent splashing by using appropriate splash guards. Cutting oil on the floor can cause a slippery condition that could result in operator injury.

===Contacts for training==

For training contact [[user:carlraymond:start|Carl Raymond]] or [[user:wreality:start|Brian Adams]]

===Safety Training===
Review the following:
  * Review of machine and shop safety rules.
  * Proper procedures for securing parts / stock.
  * Proper installation of cutting bits/tools.
  * Proper operation and control of machine.
  * Location, operation, and effect of all machine emergency stops.
  * Proper procedures for cleanup.

===Maintenance History===
  * 5/2014 -- [[equipment:lms-cnc-mill/tach|Digital Tachometer Installation]]